R&S FSW Series, Руководство пользователя

Страница: 822 / 1450

Remote Commands
R&S
®
FSW
822 User Manual 1173.9411.02 ─ 43
1
Resets the status registers.
*RST
Reset
Sets the instrument to a defined default status. The default settings are indicated in the
description of commands.
The command is equivalent to
SYSTem:PRESet
.
Note that the factory set default values can be modified to user-defined settings (see
MMEMory:LOAD:STATe
on page 1238). For more details on default values, see
Chapter 11.1, "Restoring the Default Instrument Configuration (Preset)" , on page 622.
Usage: Setting only
*SRE <Contents>
Service request enable
Sets the service request enable register to the indicated value. This command deter-
mines under which conditions a service request is triggered.
Parameters:
<Contents> Contents of the service request enable register in decimal form.
Bit 6 (MSS mask bit) is always 0.
Range:
0 to 255
*STB?
Status byte query
Reads the contents of the status byte in decimal form.
Usage: Query only
*TRG
Trigger
Triggers all actions waiting for a trigger event. In particular, *TRG generates a manual
trigger signal. This common command complements the commands of the
TRIGger
subsystem.
*TRG
corresponds to the
INITiate:IMMediate
command (see
INITiate<n>[:
IMMediate]
on page 836).
Usage: Event
Common Commands