R&S FSW Series, Руководство пользователя

Страница: 193 / 1450

Measurements and Results
R&S
®
FSW
193 User Manual 1173.9411.02 ─ 43
Remote command:
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>[:AUTO]
on page 871
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>[:AUTO]
on page 871
For manual (asymmetrical) configuration:
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>:MANual:LOWer
on page 882
[SENSe:]POWer:ACHannel:FILTer[:STATe]:GAP<gap>:MANual:UPPer
on page 883
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>:MANual:LOWer
on page 883
[SENSe:]POWer:ACHannel:FILTer:ALPHa:GAP<gap>:MANual:UPPer
on page 884
Limit Checking ← Gap Channel Definition
During an ACLR measurement, the power values can be checked whether they
exceed user-defined or standard-defined limits. A relative or absolute limit can be
defined, or both, for each individual gap channel. Both limit types are considered,
regardless whether the measured levels are absolute or relative values. The check of
both limit values can be activated independently. Furthermore, relative limits can be
defined and activated individually for ACLR or CACLR power levels.
If any active limit value is exceeded, the measured value is displayed in red and
marked by a preceding asterisk in the result table.
Note that in addition to activating limit checking for individual channels, limit checking
must also be activated globally for the MSR ACLR measurement (see
"Limit Checking"
on page 182).
Remote command:
"MSR Gap Channel Setup" on page 866
7.2.5.5 MSR Channel Names
Access : "Overview" > "Select Measurement" > "Channel Power ACLR" > "CP / ACLR
Standard" > "Standard": "Multi-Standard Radio" > "CP / ACLR Config" > "Names" tab
Channel names for all TX, adjacent, and alternate channels are user-definable.
In the "Names" tab, you can define a customized name for each channel in each sub
block. Note that the names are not checked for uniqueness.
Channel Power and Adjacent-Channel Power (ACLR) Measurement