Remote Commands for Bluetooth Measurements (K8)
R&S
®
FSV-K8
90
Operating Manual 1176.7610.02 ─ 02
Parameters:
<Excursion>
The peak excursion is the distance to a trace maximum that
must be attained before a new maximum is recognized, or the
distance to a trace minimum that must be attained before a new
minimum is recognized
*RST:
6dB in "Spectrum" mode and RF displays; 5 PCT in
AM displays, 50 kHz in FM displays, (0.5 RAD in
PM displays
Example:
CALC:MARK:PEXC 10dB
Defines peak excursion 10 dB.
CALCulate<n>:MARKer<m>:Y?
This command queries the measured value of a marker.
The corresponding marker is activated before or switched to marker mode, if neces-
sary.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweeps.
Suffix:
<n>
.
Selects the measurement window.
<m>
Selects the marker.
Return values:
<Result>
The measured value of the selected marker is returned.
Example:
INIT:CONT OFF
Switches to single sweep mode.
CALC:MARK2 ON
Switches marker 2.
INIT;*WAI
Starts a sweep and waits for the end.
CALC:MARK2:Y?
Outputs the measured value of marker 2.
Usage:
Query only
4.1.4 Other Commands in the CALCulate subsystem
CALCulate<n>:UNIT:POWer
<Unit>
This command selects the unit of the y-axis.
The unit applies to all measurement windows.
Suffix:
<n>
.
irrelevant
CALCulate subsystem
