R&S esu, Быстрый старт

Страница: 68 / 223

R&S ESU Preparing for Use
Connecting External Devices
2.18 Quick Start Guide 1302.6163.62 - 04
➢
If you want to use the SRC 2 generator configuration, move the selection bar to the lower
line of the table by using the
U d
key. Then activate the generator configuration by pressing
the ENTER key and set the checkmark in line 2 under the STATE column.
➢
Using the
U r
key, move the selection bar to the POWER [dBm] column and press the
ENTER key.
➢
Enter the desired output power and confirm with the dBm key. The power you entered will
appear in the table.
The remaining columns of the table are used to configure frequency-converting
measurements. For more information, refer to the Operating Manual, section "External
Generator Control - Option R&S FSP-B10".
This concludes the procedure for configuring the generator.
2.3.6.4 Using an External Generator as a Tracking Generator
To activate the external generator as a tracking generator, do the following:
➢
Switch on the external generator.
➢
Press the SPECTRUM hotkey to change to the analyzer mode.
➢
Press the NETWORK hotkey on the R&S ESU.
➢
Press the EXT SOURCE softkey.
Tracking generator operation using an external generator will be activated. The external
generator will switch to remote control and can be used like an internal tracking generator. For
more information about measurements with an external tracking generator, refer to the
Operating Manual, section "External Generator Control - Option R&S FSP-B10".
Switching off the tracking generator:
➢
Press the NETWORK hotkey on the R&S ESU.
➢
Press the EXT SOURCE softkey.
➢
Change the EXT SRC softkey to OFF by pressing it.
You can also change the output power of the generator by using the
SOURCE POWER softkey located in the NETWORK menu.
When you switch off tracking generator operation using an external
generator, control on the IEC2 is automatically released and the
generator is returned to
LOCAL mode.