R&S ESU Series, Руководство по эксплуатации

Страница: 443 / 855

R&S ESU Remote Control – Description of Commands
Introduction
6.4 Operating Manual 1302.6163.12 - 03
6.1 Introduction
This chapter describes all remote control commands of the R&S ESU in detail. For details on the nota-
tion of the remote control commands refer to
“Notation” on page 6.5 .
Before sending a command sequence consisting of commands described in chapter 6, please make
sure that the analyzer mode is active, by one of the following actions:
• Set the preset compatibility to the analyzer mode (
SYST:PRES:COMP FSP
command).
• Perform a preset (*RST).
• Use the
INST:SEL SAN
command.
The remote control commands are sorted according to the subsystem they belong to. The following
subsystems are included in this chapter:
• “Common Commands” on page 6.8
• “ABORt Subsystem” on page 6.11
• “CALCulate Subsystem” on page 6.12
• “CALibration Subsystem” on page 6.98
• “DIAGnostic Subsystem” on page 6.100
• “DISPlay Subsystem” on page 6.104
• “FORMat Subsystem” on page 6.114
• “HCOPy Subsystem” on page 6.115
• “INITiate Subsystem” on page 6.125
• “INPut Subsystem” on page 6.129
• “INSTrument Subsystem” on page 6.134
• “MMEMory Subsystem” on page 6.138
• “OUTPut Subsystem” on page 6.151
• “SENSe Subsystem” on page 6.152
• “SOURce Subsystem” on page 6.220
• “STATus Subsystem” on page 6.226
• “SYSTem Subsystem” on page 6.235
• “TRACe Subsystem” on page 6.246
• “TRIGger Subsystem” on page 6.260
• “UNIT Subsystem” on page 6.262
An alphabetical list of all remote commands is provided at the end of this chapter in section “Alphabetical
List of Remote Commands” on page 6.336 . Additionally, a subset of remote commands of HP models is
supported. These commands are listed in section “GPIB Commands of HP Models 856xE, 8566A/B,
8568A/B and 8594E” on page 6.263 .
For information on differences between the FSP and FSE families refer to section “Differences in GPIB
Behavior between the FSP and the FSE Families of Instruments” on page 6.289 .