R&S ESU Series, Руководство по эксплуатации

Страница: 312 / 855

Operating Manual 1302.6163.12 - 03 4.281
R&S ESU Instrument Functions
Basic Settings
➢
The following instrument settings will then be changed:
Remote command:
SYST:LANG "SCPI" | "8560E" |
"8561E" | "8562E" | "8563E" |
"8564E" | "8565E" | "8566A" |
"8566B" | "8568A" | "8568A_DC" |
"8568B" | "8568B_DC" | "8591E" |
"8594E" | "71100C" | "71200C" |
"71209A"
IF GAIN NORM/
PULS
The IF GAIN NORM/PULS softkey configures the internal IF gain settings in HP
emulation mode due to the application needs. This setting is only taken into account
for resolution bandwidth < 300 kHz.
This softkey is only available, if a HP languge is selected via the GPIB LANGUAGE
softkey.
Remote command:
SYST:IFG:MODE PULS
SWEEP REP
ON/OFF
The SWEEP REP ON/OFF softkey controls a repeated sweep of the
E1
and
MKPK
HI
HP model commands (for details on the commands refer to “GPIB Commands of
HP Models 856xE, 8566A/B, 8568A/B and 8594E” on page 6.263 ). If the repeated
sweep is OFF, the marker is set without sweeping before.
Model # of Trace
Points Start Freq. Stop Freq. Ref Level Input
Coupling
8566A/B 1001 2 GHz 22 GHz 0 dBm DC
8568A/B 1001 0 Hz 1.5 GHz 0 dBm AC
8560E 601 0 Hz 2.9 GHz 0 dBm AC
8561E 601 0 Hz 6.5 GHz 0 dBm AC
8562E 601 0 Hz 13.2 GHz 0 dBm AC
8563E 601 0 Hz 26.5 GHz 0 dBm AC
8564E 601 0 Hz 40 GHz 0 dBm AC
8565E 601 0 Hz 50 GHz 0 dBm AC
8594E 401 0 Hz 3 GHz 0 dBm AC
Notes regarding switch over to 8566A/B and 8568A/B on R&S FSUP
• The stop frequency indicated in the table may be limited to the corresponding
frequency of the R&S ESU, if required.
NORM Optimized for high dynamic range,
overload limit is close to reference level.
PULS Optimized for pulsed signals,
overload limit up to 10 dB above reference level.
In single sweep mode, switch off this softkey before you set the marker via the
E1
and
MKPK HI
commands in order to avoid sweeping afresh.