R&S DVMS1, Начало работы

Страница: 23 / 60

Interfaces and Connectors
R&S
®
DVMS1
17 Getting Started 2113.7619.02 ─ 12
Pin Signal Pin Signal
7 DDC data 21 Not used
8 Analog vertical sync 22 TMDS clock shield
9 TMDS data 1- 23 TMDS clock+
10 TMDS data 1+ 24 TMDS Clock-
11 TMDS data 1 shield C1 Not used
12 Not used C2 Not used
13 Not used C3 Not used
14 +5V power C4 Not used
3.2.5 LAN Interface
The 1 gigabit LAN interface (1000 Base
‑
T) can be used to connect the R&S DVMS to a
local network for remote control, printouts and data transfer. The assignment of the
RJ45 connector supports twisted-pair category 7 STP cables in a star configuration
(STP for shielded twisted pair).
Two LEDs indicate the status of the LAN connection.
●
Green LED
–
LED off: No connection
– LED on (steady): Connection is established.
– LED blinking: Connection is established, communication line is in a busy state.
●
Yellow LED
–
LED off: Connection speed is 10 Mbit/s or 100 Mbit/s.
– LED on (steady): Connection speed is 1000 Mbit/s.
Do not connect or disconnect the network cable until the instrument is switched off.
Otherwise, the network connection cannot be reliably detected.
Electromagnetic interference (EMI) can affect the measurement results. To avoid any
impact, use category 7 cables.
Further information:
●
Chapter 7, "Operating the R&S DVMS in a LAN" , on page 38
Rear Panel