LTE SRS Measurement
R&S
®
CMW-KM5xx/-KS5xx
831
User Manual 1173.9628.02 ─ 16
This parameter can be used to prevent unwanted trigger events due to fast power var-
iations.
Remote command:
5.3.2.4
Limit Settings
The "Limits" in the "LTE SRS Configuration" dialog define upper limits for the power
results.
For details see
chapter 5.2.5, "Limit Settings and Conformance Requirements"
Fig. 5-9: Limit settings
Limits
The limits can be configured via the following remote commands.
Remote command:
5.3.2.5
Additional Softkeys and Hotkeys
The "LTE SRS" measurement provides some softkey/hotkey combinations which have
no equivalent in the configuration dialog. Most of these hotkeys provide display config-
urations (like diagram scaling). They are self-explanatory and do not have any remote-
control commands assigned.
The remaining softkeys > hotkeys are described below. They are displayed only while
the combined signal path scenario is active and are provided by the "LTE Signaling"
application selected as master application. See also
While one of the signaling softkeys is selected, the "Config" hotkey opens the configu-
ration dialog of the signaling application, not the configuration dialog of the measure-
ment.
Signaling Parameter > ...
Provides access to the most essential settings of the "LTE Signaling" application.
Remote command:
Use the commands of the signaling application.
LTE Signaling
Select this softkey and press ON | OFF to turn the downlink signal transmission on or
off.
GUI Reference
深圳德标仪器
135-1095-0799
