R&S CMW-KG4 Series, Руководство пользователя, Страница: 798 / 988

WCDMA TPC Measurement
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
798 User Manual 1173.9657.02 ─ 11
└ TPC Auto Execute ........................................................................................ 799
└ TPC Test Step Settings ................................................................................ 799
Max. Power E-DCH .....................................................................................................799
└ Measurement Length .................................................................................... 800
└ TPC Auto Execute ........................................................................................ 800
Power Control in UL CM ............................................................................................. 800
└ Measurement Length .................................................................................... 800
└ TPC Auto Execute ........................................................................................ 800
Change of TFC ............................................................................................................800
└ Measurement Length .................................................................................... 800
└ Number of Steps Up/Down ........................................................................... 800
Measure on Exception
Specifies whether measurement results that the R&S CMW identifies as faulty or inac-
curate are rejected. A faulty result occurs e.g. when an overload is detected or when
the RF receiver is underdriven. In remote control, the cause of the error is indicated by
the "reliability indicator".
●
Off: Faulty results are rejected. The measurement is continued; the statistical
counters are not re-set. Use this mode to ensure that a single faulty result does not
affect the entire measurement.
●
On: Results are never rejected. Use this mode e.g. for development purposes, if
you want to analyze the reason for occasional wrong transmissions.
Remote command:
CONFigure:
​
WCDMa:
​
MEAS<i>:
​
TPC:
​
MOEXception
​
Mode
Indicates the measurement mode resulting from the currently selected TPC setup.: , "",
"Max. Power E-DCH", "", or "".
●
Monitor for TPC setups: closed loop, alternating, all 1, all 0, single pattern alternat-
ing, single pattern all 1, single pattern all 0, continuous pattern, phase discontinuity
up, and phase discontinuity down
●
Change of TFC
●
Max. Power E-DCH
●
Inner Loop Power Control for TPC setups: TPC test step ABC, E, F, EF, GH,
●
UL Compressed Mode
Remote command:
CONFigure:
​
WCDMa:
​
MEAS<i>:
​
TPC:
​
MODE?
​
Monitor > Measurement Length
Defines the number of slots to be measured in "Monitor" mode.
Remote command:
CONFigure:
​
WCDMa:
​
MEAS<i>:
​
TPC:
​
MONitor:
​
MLENgth
​
Inner Loop Power
Controls measurements in "Inner Loop Power Control" mode.
GUI Reference
深圳德标仪器
135-1095-0799