R&S CMW-KG4 Series, Руководство пользователя, Страница: 134 / 988

WCDMA Signaling
R&S
®
CMW-KG4xx/-KM4xx/-KS4xx
134 User Manual 1173.9657.02 ─ 11
Enables or disables the reduced signaling mode. For an introduction to this mode
see
chapter 2.2.3, "Reduced Signaling Mode" , on page 20.
Remote command:
CONFigure:
​
WCDMa:
​
SIGN<i>:
​
CELL:
​
RSIGnaling
​
Connection Setup
Contains the most important connection configuration parameters. Depending on a
connection type (e.g. Voice, Test Mode,...), the related connection parameters in the
lower part are shown. See
chapter 2.4.11, "Connection Configuration" , on page 179.
If no connection is established, select the parameters to be used for the next mobile
terminating call.
In the state "Connection Established", the values used for the current connection are
displayed.
During a packet data connection, the current SRB data rate in DL and UL is shown in
addition.
If a CS and PS multi call is established, information relevant for the CS voice call and
for the PS packet data call is displayed.
2.4.2 Signaling and Connection Control
The individual connection states are controlled via the ON | OFF key, via hotkeys and
via the UE.
The available hotkeys depend on the current connection state. Below all possible hot-
keys are described.
For background information refer to chapter 2.2.8, "Connection States" , on page 27.
ON | OFF (key) / WCDMA-UE Signaling (softkey)
The ON | OFF key is used to turn the DL signal transmission on or off. The current
state is shown by the softkey. The signal transmission can be switched off any time,
independent of the current connection state. A yellow sandglass symbol indicates that
the signaling generator is currently turned on or off.
The state "RDY" means that the signaling application is ready to receive an inter-RAT
handover from another signaling application (e.g. from LTE). This state is initiated by
the application acting as source of the handover.
While the DL signal is on, the signaling application provides a trigger signal, see chap-
ter 2.2.13, "Trigger Signals" , on page 52.
Remote command:
SOURce:
​
WCDMa:
​
SIGN<i>:
​
CELL:
​
STATe
​
SOURce:
​
WCDMa:
​
SIGN<i>:
​
CELL:
​
STATe:
​
ALL?
​
GUI Reference
深圳德标仪器
135-1095-0799