R&S AFQ100A
Output Block
1401.3084.32 4.57
E-3
Output Block
Introduction
The dialog for adjusting the output ports can be accessed in the
Output
function block by selecting
config...
or by selecting
Output
in the
Edit
menu.
In the upper part of the dialog, the output (analog or digital) is selected and activated. The dialog differs
depending on the selected output.
State
Switches On or Off the active output. The selected output, either
analog or digital is activated or deactivated, respectively.
Remote-control command:
SOUR:OUTP:STAT ON
Active Output
Selects the output mode. Two output modes cannot be actived at the
same time. The selection offered depends on the fitted output boards.
If there is only one board fitted, e.g. an analog one, the menu item
Analog Out
is selectable solely. Only instrument version R&S AFQ-
B18 is equipped with a digital output board. Then, the user decides
whether the analog or the digital board shall be switched on. If a
second digital output board is installed, the user has to select either
DIGITAL1
or
DIGITAL2
. In the same way the user has to select
either
ANALOG1
or
ANALOG2
if the instrument is equipped with two
analog output boards.
Digital /
Analog
One digital and one analog output are fitted. The
digital or analog output can be activated.
Remote-control command:
SOUR:OUTP:AOUT DIG | ANAL
Analog1 /
Analog2
Two analog outputs are fitted. One of them can be
activated.
Remote-control command:
SOUR:OUTP:AOUT ANALOG1 | ANALOG2
Digital1
/Digital2
Two digital outputs are fitted. One of them can be
activated.
Remote-control command:
SOUR:OUTP:AOUT DIGITAL1 | DIGITAL2
In the following, first the settings for the analog output and then the settings for the digital output are
described.
