Tap the
Timers
tab to view timers,
odometer readings, and times.
Tap the
Logs
tab to view a list of mileage logs by quarter.
Tap on a quarter to view individual logs by state.
Enter truck information and access truck-specific use tools.
Show location on the map and view navigation instructions.
Change driver status.
Choose a destination.
Select TND and route preferences.
Mute/unmute the speaker.
Adjust speaker volume.
GPS Signal Indicator
To Power the Device:
On
Press and hold the Power Key for two (2) seconds.
(Device powers on in 5 seconds.)
Off
Press and hold the Power Key for five (5) seconds.
To Enter or Return from Standby Mode:
Press and release the Power Key.
Overview
See Safety Information included with the device for
warnings and precautions.
NOTE:
To maximize battery life, plug in and charge the
navigation unit for the first 2 hours of use.
Install the Mount
Note:
Follow all local regulations governing the placement of
the mount.
Select an area with a line of sight to the sky and GPS satellites
to ensure reliable GPS information.
Clean and dry the mounting area.
Remove the suction cup protective film.
Adjust the angle and secure the cradle to the mount
using the thumbscrew.
Pull the suction cup lever up to release suction.
Place and hold the mount suction cup against the
mounting surface.
Press the suction cup lever down until it snaps into place.
Angle the bottom of the device into the cradle and press
the top of the device towards the cradle until you hear
the upper clip latch into place.
Plug the power cord into the device and the vehicle’s
12-volt power source.
Enter Truck Information
Tap
Truck Tools
>
Truck Info
.
Tap and to view all options.
Tap the option button to be changed.
Enter new truck information settings.
Tap
Back
to save changes.
View Timers and Logs
Countdown timers are controlled by the Driver Status (
Driving
,
On Duty
, or
Off Duty)
selected on the Main Menu.
Tap
Truck Tools
.
Tap
Timers and Logs
.
Adjust the navigation device so that it can be easily seen
and does not block the driver’s line of sight.
Main Menu
Quick Start Guide
1
1
1
1
1
3
3
3
3
3
4
4
4
4
4
5
5
5
5
5
6
7
8
6
7
8
9
6
7
8
2
2
2
2
2
NOTE:
Use the
Reset button
(located on the
back of the device)
to restore factory
settings and restart
the device.
Power Key
Battery Power Indicator
Bright Red:
Device is plugged
in and the battery is charging.
Bright Green:
Device is
plugged in and the battery
is fully charged.
Light Green:
Device is
in Standby Mode.
Note:
Do not place
the mount in an airbag
deployment area.
On the left,
tap on an
option
On the right,
enter settings
for the option
