12
Speed Sensor:
Your bike is equipped with a speed sensor, the sensor consists of a sensor and a magnet. The sensor is mounted on the
frame near the rear tire and the magnet is attached to a spoke on the rear wheel. Every time the rear wheel makes a
revolution the magnet trips the sensor and signals to the LCD that the bike is in motion. It is very important that the
magnet on the spoke is properly aligned to the sensor. The magnet is the shiny part of the sensor and not the flathead
screwdriver side. The magnet should face the square (box) area of the sensor, not the circle part that is used to attach to
the frame.
USB Charging,
Your Bike is equipped with USB charging while the bike is turned on. You can charge devices such as cell phones, and
other devices that use USB charging cables. Locating your USB port; most USB ports are located at the bottom of the LCD
screen, while Megatron and Krusader models are located at the bottom of the power off/on switch.
Dual Battery Technology
With the battery installed from the bottom of your bike frame, you can install a secondary battery on the top of your
bike frame. The additional battery is a 48v 14ah battery. Contact Rambo Bikes for more information.
Suspension Fork,
Your bike has front suspension that is mainly set and adjusted by air pressure. To test if your suspension is set properly,
there should be 20% compression on the suspension when you are in riding position. If the suspension is too stiff or too
soft, it will need to be adjusted using an air suspension air pump. In most cases the PSI in the fork will be around 120lbs.
There are also quick adjustments for the fork on the top of the suspension, turning the knob towards the lock will make
the fork stiffer and turning away will make the suspension softer.
ASSEMBLY
Tools Required
One (1) 16mm wrench
One (1) 15mm wrench
One (1) 4mm Allen wrench
Two (2) 5mm Allen wrench
Side cutting pliers
Air Pump
