8
o
4mm Allen Key
o
5mm Allen Key
o
6mm Allen Key
o
13mm Open Ended Wrench
o
15mm Open Ended Wrench
Figure 1. Unpacking your Rambo Bike
:
•
Carefully remove bike and components from
the carton as shown in Figure 1.
•
Check to be sure all components are present
and not damaged.
o
Frame with rear wheel attached
o
Front wheel
o
Through axle
o
Handlebar assembly
o
Seat and seat post assembly
o
Pedals (left and right)
o
Motor (E-Bike only)
o
Battery (E-Bike only)
o
Charger (E-Bike only)
o
Controller display (E-Bike only)
Serial Number:
•
Locate your bike serial number which is
stamped and located on the
head tube
as
shown in
Figure 2.
•
Write down the serial number in the owner’s
manual and store in a safe place
.
Section 4 - Assembly Instructions
This manual provides instructions on how to assemble your new Rambo Bike as it comes from the factory.
If you feel you do not understand the instructions, have the proper tools or would prefer a qualified
technician perform the assembly, take your new Rambo Bike to your local bike shop.
This manual may contain some illustrations and information that does not apply to the model of bike you
may have. Some of the information contained in this manual refers to bikes in general as there are many
models, with a variety of equipment, so no one manual can cover them all. If you have any questions after
reading the information in this manual, contact your local bike shop or Rambo directly.
Tools Needed (not included in packaging):
Front Wheel Assembly:
Read all warning labels associated with this product.
Figure 3
Figure 1
Figure 2
