RAM TRX 2022, Руководство по функциям

Страница: 62 / 96

60 MULTIMEDIA
V
ALET
M
ODE
To enter Valet Mode, press the Valet Mode button
from the All Profiles menu on the touchscreen. For
more information on Profiles, please refer to your
Uconnect Owner’s Manual Supplement.
While in Valet Mode, the following vehicle
configurations are set and locked to prevent
unauthorized modification:

Transmission upshifts earlier than normal.

Steering and Suspension are set to their Street
settings.

Steering wheel paddle shifters are disabled.

The ESC Off button is disabled.

The Launch Control button is disabled.

Engine power is reduced.
When the vehicle is started or was previously
placed in Valet Mode, a pop-up will display that the
vehicle is in Valet Mode. Select “Yes” to deactivate
valet mode. Alternatively, press the Locked Profile
icon in the Upper Status Bar to exit Valet Mode.
Enter your four-digit Valet Mode PIN and press
“Go”. Valet Mode will be deactivated. The
Uconnect system will load the last active Profile
before the vehicle was placed in Valet Mode.
NOTE:
If your four-digit PIN is lost or forgotten, the vehicle
will exit Valet Mode after a battery disconnect for
approximately five minutes. Reconnect the battery
and cycle the ignition to the ON/RUN position. The
vehicle will be in Auto Mode.
22_DT_TRX_SU_EN_USC_t.book Page 60