RAM PROMASTER CITY, Руководство пользователя

Страница: 13 / 280

GETTING TO KNOW YOUR VEHICLE 11
Replacing The Battery In The Key Fob
The recommended replacement battery is
CR2032.
NOTE:

Customers are recommended to use a
battery obtained from Mopar. Aftermarket
coin battery dimensions may not meet the
original OEM coin battery dimensions.

Perchlorate Material – special handling may
apply. See www.dtsc.ca.gov/hazard -
ouswaste/perchlorate.
1. Push the mechanical key release button
and release the mechanical key to access
the battery case screw located on the side
of the key fob.
2. Rotate the screw located on the side of the
key fob using a small screwdriver.
Key Fob Screw Location
3. Take out the battery case. Remove and
replace the battery observing its polarity.
4. Refit the battery case inside the key fob and
turn the screw to lock it into place.
Programming And Requesting Additional Key
Fobs
Programming the key fob may be performed by
an authorized dealer.
NOTE:
Once a key fob is programmed to a vehicle, it
cannot be re-purposed and reprogrammed to
another vehicle.
Duplication of keys may be performed at an
authorized dealer. The VIN is required for
authorized dealer replacement of keys.
NOTE:
Only keys that have been programmed to the
vehicle electronics can be used to start the
vehicle. Once a Sentry Key has been
programmed to a vehicle, it cannot be
programmed to any other vehicle. When having
the Sentry Key Immobilizer system serviced,
bring all vehicle keys with you to an authorized
dealer.
WARNING!

Always remove the key fobs from the
vehicle and lock all doors when leaving the
vehicle unattended.

Always remember to place the ignition in
the OFF mode.
2
21_VM_OM_EN_USC_t.book Page 11