RAM CHASSIS CAB 2024, Руководство пользователя

Страница: 292 / 360

Refrigerant Recovery And Recycling
R-134a — If Equipped
R-134a Air Conditioning Refrigerant is a Hydrofluoro-
carbon (HFC) that is an ozone-friendly substance. The
manufacturer recommends that air conditioning service
be performed by an authorized dealer or other service
facilities using recovery and recycling equipment.
NOTE:
Use only manufacturer approved A/C system PAG com-
pressor oil and refrigerants.
Refrigerant Recovery And Recycling
R-1234yf — If Equipped
R-1234yf Air Conditioning Refrigerant is a Hydrofluoroolefin
(HFO) that is endorsed by the Environmental Protection
Agency and is an ozone-friendly substance with a low
global-warming potential. The manufacturer recommends
that air conditioning service be performed by an authorized
dealer using recovery and recycling equipment.
NOTE:
Use only manufacturer approved A/C system PAG com-
pressor oil, and refrigerants.
Cabin Air Filter Replacement
For the proper maintenance intervals page 279.
WARNING!
Do not remove the cabin air filter while the vehicle is run-
ning, or while the ignition is in the ACC or ON/RUN mode.
With the cabin air filter removed and the blower operat-
ing, the blower can contact hands and may propel dirt
and debris into your eyes, resulting in personal injury.
The cabin air filter is located in the fresh air inlet behind
the glove compartment. Perform the following proce-
dure to replace the filter:
1. Open the glove compartment and remove all contents.
2. With the glove compartment door open, remove the
glove compartment tension tether and tether clip by
sliding the clip toward the face of the glove compart-
ment door. Lift the clip out of glove compartment
door and release into dash panel.
3. There are travel stops on both sides of the glove
compartment. Push inward on right side of the glove
compartment travel stop to disengage the stop.
Then pull the right of the glove compartment out-
ward (away from the hinge) to disengaging the right
side of the compartment from the hinge. Continue
by removing the left side from the hinge by slightly
lowering the compartment while pulling outward
until it is completely disengaged from the hinge.
4. Remove the filter cover by pushing in on the finger
tabs on each end of the filter cover.
Right Side Of Glove Compartment
1 — Glove Compartment Door
2 — Glove Compartment Tension Tether
Glove Compartment
1 — Glove Compartment Travel Stop
2 — Glove Compartment Tension Tether
3 — Glove Compartment Door
Filter Cover
290 SERVICING AND MAINTENANCE