94
GETTING TO KNOW YOUR VEHICLE
4. Rotate the center handle horizontally to
secure the side gates in the closed position.
Side Gates Closed
5. Lock the center handle to secure the panel
into place.
Bed Rail Tie-Down System
NOTE:
This feature is available for vehicles both
equipped, or not equipped, with a RamBox.
There are two adjustable cleats on each side of
the bed that can be used to assist in securing
cargo.
Adjustable Cleats
Each cleat must be located and tightened down
in one of the detents, along either rail, in order
to keep cargo properly secure.
To move the cleat to any position on the rail,
turn the nut counterclockwise, approximately
three turns. Then pull out on the cleat and slide
it to the detent nearest the desired location.
Make sure the cleat is seated in the detent and
tighten the nut.
Adjustable Cleat Assembly
CAUTION!
The maximum load per cleat should not
exceed 250 lbs (113 kg) and the angle of the
load on each cleat should not exceed 45
degrees above horizontal, or damage to the
cleat or cleat rail may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
19_DJD2_OM_EN_USC_t.book Page 94