IN CASE OF EMERGENCY
307
Rear Lamp Bar ID Marker (Dual Rear Wheels)
— If Equipped
1. Loosen the two screws and the housing to
gain access to the bulb sockets.
Screw Locations
2. Turn the socket ¼ turn counterclockwise to
access the bulb.
3. Pull the bulb straight out from the socket.
4. Reverse the procedure for installation of the
bulbs and housing.
Side Marker Lamps (Dual Rear Wheels) — If
Equipped
Side Marker Lamp Locations
1. Push rearward on the side marker lamp
assembly.
2. Pull the entire assembly from the fender.
3. Turn the socket ¼ turn counterclockwise
and remove from assembly to access the
bulb.
4. Pull the bulb straight out from socket.
5. Reverse the procedure for installation of the
bulbs and housing.
FUSES
WARNING!
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse. Never
replace a fuse with another fuse of higher
amp rating. Never replace a blown fuse with
metal wires or any other material. Do not
place a fuse inside a circuit breaker cavity
or vice versa. Failure to use proper fuses
may result in serious personal injury, fire
and/or property damage.
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
If the replaced fuse blows again, contact an
authorized dealer.
If a general protection fuse for safety
systems (air bag system, braking system),
power unit systems (engine system, trans
-
mission system) or steering system blows,
contact an authorized dealer.
6
19_DJD2_OM_EN_USC_t.book Page 307