GETTING TO KNOW YOUR VEHICLE
81
B
ED
R
AIL
T
IE
-D
OWN
S
YSTEM
—
I
F
E
QUIPPED
NOTE:
This feature is only available for vehicles equipped with a
RamBox.
There are two adjustable cleats on each side of the bed
that can be used to assist in securing cargo.
Adjustable Cleats
Each cleat must be located and tightened down in one of
the detents, along either rail, in order to keep cargo
properly secure.
To move the cleat to any position on the rail, turn the nut
counterclockwise several turns. Then pull out on the cleat
and slide it to the detent nearest the desired location.
Make sure the cleat is seated in the detent and tighten
the nut.
Adjustable Cleat Assembly
Cleat Removal (With Tonneau Cover)
To remove the cleats from the utility rail, remove the end
cap screw located in the center of the end cap, using a
#T30 Torx head driver. Remove the end cap and slide the
cleat off the end of the rail.
End Cap Screw Location With Tonneau Cover
CAUTION!
The maximum load per cleat should not exceed 250 lb
(113 kg) and the angle of the load on each cleat should
not exceed 45 degrees above horizontal, or damage to
the cleat or cleat rail may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
2
23_DJD2_OM_EN_USC_t.book Page 81
Содержание 2500 2023
Страница 94: ...92 GETTING TO KNOW YOUR INSTRUMENT PANEL MIDLINE INSTRUMENTCLUSTER GASENGINE 23_DJD2_OM_EN_USC_t book Page 92...
Страница 100: ...98 GETTING TO KNOW YOUR INSTRUMENT PANEL MIDLINE INSTRUMENTCLUSTER DIESEL ENGINE 23_DJD2_OM_EN_USC_t book Page 98...
Страница 102: ...100 GETTING TO KNOW YOUR INSTRUMENT PANEL HIGHLINE INSTRUMENT CLUSTER DIESEL ENGINE 23_DJD2_OM_EN_USC_t book Page 100...
Страница 104: ...102 GETTING TO KNOW YOUR INSTRUMENT PANEL PREMIUM INSTRUMENT CLUSTER DIESEL 23_DJD2_OM_EN_USC_t book Page 102...