GETTING TO KNOW YOUR VEHICLE
95
The outboard ends should be positioned in front
of the cargo tie-down loops.
Cargo Tie-Down Loop
SLIDE-IN CAMPERS
C
AMPER
A
PPLICATIONS
Certain truck models are not recommended for
slide-in campers. To determine if your vehicle is
excluded, please refer to the “Consumer
Information Truck-Camper Loading” document
at www.ramtrucks.com. For safety reasons,
follow all instructions in this important
document.
NOTE:
When a cap or pickup camper is installed on a
vehicle, an alternate Center High Mounted Stop
Lamp (CHMSL) must be provided.
TRI-FOLD TONNEAU COVER — IF EQUIPPED
The Tri-Fold Tonneau Cover can be installed on
the truck bed to protect your gear and cargo.
T
RI
-F
OLD
T
ONNEAU
C
OVER
R
EMOVAL
To remove the Tonneau Cover, use the following
steps:
1. Open the tailgate to gain access to the rear
pair of Tonneau Cover clamps located on
the underside of the cover.
Location Of Rear Latches
NOTE:
If clamp wire is damaged replace immediately.
2. Pull both clamp handles down to release
the Tonneau Cover’s rear panel.
Released Position
WARNING!
To avoid inhaling carbon monoxide, which is
deadly, the exhaust system on vehicles
equipped with “Cap or Slide-In Campers”
should extend beyond the overhanging
camper compartment and be free of leaks.
2
21_DJD2_OM_EN_USC_t.book Page 95
