2. Turn the socket a quarter turn counterclockwise to
access the bulb.
3. Pull the bulb straight out from the socket.
4. Reverse the procedure for installation of the bulbs
and housing.
Side Marker Lamps (Dual Rear Wheels)
— If Equipped
1. Push rearward on the side marker lamp assembly.
2. Pull the entire assembly from the fender.
3. Turn the socket a quarter turn counterclockwise and
remove from assembly to access the bulb.
4. Pull the bulb straight out from socket.
5. Reverse the procedure for installation of the bulbs
and housing.
FUSES
WARNING!
•
When replacing a blown fuse, always use an appro-
priate replacement fuse with the same amp rating
as the original fuse. Never replace a fuse with
another fuse of higher amp rating. Never replace a
blown fuse with metal wires or any other material.
Do not place a fuse inside a circuit breaker cavity
or vice versa. Failure to use proper fuses may
result in serious personal injury, fire and/or prop-
erty damage.
•
Before replacing a fuse, make sure that the igni-
tion is off and that all the other services are
switched off and/or disengaged.
•
If the replaced fuse blows again, contact an autho-
rized dealer.
•
If a general protection fuse for safety systems (air
bag system, braking system), power unit systems
(engine system, transmission system) or steering
system blows, contact an authorized dealer.
POWER DISTRIBUTION CENTER
The Power Distribution Center is located in the engine
compartment near the battery. This center contains
cartridge fuses, micro fuses, relays, and circuit break-
ers. A description of each fuse and component may be
stamped on the inside cover, otherwise the cavity num-
ber of each fuse is stamped on the inside cover that
corresponds to the following chart.
Side Marker Lamp Locations
Power Distribution Center Location
260
IN CASE OF EMERGENCY