RAM 2500 2019, Руководство пользователя

Страница: 24 / 332

GETTING TO KNOW YOUR VEHICLE
22
Driver Two Memory Position Recall

To recall the memory setting for driver two
using the memory buttons on the door
panel, push memory button (2).

To recall the memory settings for driver
two using the key fob, push the unlock
button on the key fob linked to memory
position 2.
A recall can be cancelled by pushing any of
the memory buttons during a recall (S, 1, or
2). When a recall is canceled, the driver's
seat and the power pedals (if equipped) stop
moving. A delay of one second will occur
before another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver’s seat
positioning to enhance driver mobility when
entering and exiting the vehicle.
The distance the driver’s seat moves
depends on where you have the driver’s seat
positioned when you remove the key fob from
the ignition.

When you remove the key fob from the
ignition, the driver’s seat will move about
2.4 inches (60 mm) rearward if the
driver’s seat position is greater than or
equal to 2.7 inches (67.7 mm) forward of
the rear stop. The seat will return to its
previously set position when you place the
ignition into the ACC or RUN position.

When you remove the key fob from the
ignition, the driver’s seat will move to a
position 0.3 inches (7.7 mm) forward of
the rear stop if the driver’s seat position is
between 0.9 inches and 2.7 inches
(22.7 mm and 67.7 mm) forward of the
rear stop. The seat will return to its previ
-
ously set position when you place the igni -
tion to the ACC or RUN position.

The Easy Entry/Easy Exit feature is
disabled when the driver’s seat position is
less than 0.9 inches (22.7 mm) forward of
the rear stop. At this position, there is no
benefit to the driver by moving the seat for
Easy Exit or Easy Entry.
Each stored memory setting will have an
associated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled
when the vehicle is delivered from the
factory. The Easy Entry/Exit feature is
enabled (or later disabled) through the
programmable features in the Uconnect
system.
Refer to “Uconnect Settings” in “Multi -
media” in the Owner’s Manual for further
information.
Heated Seats — If Equipped
On some models, the front and rear seats
may be equipped with heaters located in the
seat cushions and seat backs.
WARNING!

Persons who are unable to feel pain to
the skin because of advanced age,
chronic illness, diabetes, spinal cord
injury, medication, alcohol use, exhaus
-
tion or other physical condition must
exercise care when using the seat heater.
It may cause burns even at low tempera
-
tures, especially if used for long periods
of time.

Do not place anything on the seat or
seatback that insulates against heat,
such as a blanket or cushion. This may
cause the seat heater to overheat. Sitting
in a seat that has been overheated could
cause serious burns due to the increased
surface temperature of the seat.
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 22