RAM 2500 2019, Руководство пользователя

Страница: 17 / 332

15
NOTE:

If your power door locks were unlocked,
Remote Start will automatically lock the
doors.

If an engine fault is present or fuel level is
low, the vehicle will start and then shut
down in 10 seconds.

The park lamps will turn on and remain on
during Remote Start mode.

For security, power window and power
sunroof operation (if equipped) are
disabled when the vehicle is in the
Remote Start mode.

The engine can be started two consecutive
times (two 15-minute cycles) with the key
fob. However, the ignition must be placed
in the ON/RUN position before you can
repeat the start sequence for a third cycle.
General Information
The following regulatory statement applies to
all radio frequency (RF) devices equipped in
this vehicle:
This device complies with Part 15 of the FCC
Rules
and with Industry Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions:
1. This device may not cause harmful inter -
ference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE:
Changes or modifications not expressly
approved by the party responsible for compli
-
ance could void the user’s authority to
operate the equipment.
VEHICLE SECURITY ALARM
The vehicle security alarm monitors the
vehicle doors, tailgate, and ignition for unau
-
thorized operation. When the vehicle security
alarm is activated, interior switches for door
locks are disabled. The system will turn the
horn off after 29 seconds, 5 seconds
between cycles, up to 8 cycles if the trigger
remains active and then the vehicle security
alarm will rearm itself.
To Arm The System
Follow these steps to arm the vehicle secu -
rity alarm:
1. Remove the key from the ignition system
(refer to "Starting The Engine" in
"Starting And Operating" for further infor
-
mation).

Make sure the vehicle ignition system
is "OFF."
2. Perform one of the following methods to
lock the vehicle:

Push lock button on the interior power
door lock switch with the driver and/or
passenger door open.

Push the lock button on the exterior
Passive Entry Door Handle with a valid
key fob available in the same exterior
zone (refer to "Keyless Enter- N-Go —
Passive Entry" in "Getting To Know
Your Vehicle" for further information).

Push the lock button on the key fob.
3. If any doors are open, close them.
The vehicle security alarm will set when you
use the power door locks, or use the key fob
to lock the doors. After all the doors are
2019_RAM_2500_3500_UG_USA=GUID-8BBFE451-BF24-4E82-808A-AE2460D39A05=1=en=.book Page 15