RAM 2015 1500, Руководство по эксплуатации, Страница: 92 / 998

Driver Two Memory Position Recall
•
To recall the memory setting for driver two
using the memory switch, press MEMORY
button number 2 on the memory switch.
•
To recall the memory settings for driver two
using the RKE transmitter, press the UN-
LOCK button on the RKE transmitter linked
to memory position 2.
A recall can be cancelled by pressing any of the
MEMORY buttons during a recall (S, 1, or 2).
When a recall is cancelled, the driver’s seat,
and the power pedals (if equipped) stop mov-
ing. A delay of one second will occur before
another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you remove the Key Fob from the ignition (or
change the ignition to OFF, for vehicles
equipped with Keyless Enter-N-Go™).
•
When you remove the Key Fob from the
ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-
Go™), the driver seat will move about 2.4 in
(60 mm) rearward if the driver seat position is
greater than or equal to 2.7 in (67.7 mm)
forward of the rear stop. The seat will return
to its previously set position when you place
the ignition into the ACC or RUN position.
•
When you remove the Key Fob from the
ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-
Go™), the driver seat will move to a position
0.3 in (7.7 mm) forward of the rear stop if the
driver seat position is between 0.9 in and
2.7 in (22.7 mm and 67.7 mm) forward of the
rear stop. The seat will return to its previously
set position when you place the ignition to the
ACC or RUN position.
•
The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than 0.9
in (22.7 mm) forward of the rear stop. At this
position, there is no benefit to the driver by
moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later dis-
abled) through the programmable features in
the Uconnect® system. Refer to “Uconnect®
Settings/Customer Programmable Features” in
“Understanding Your Instrument Panel” for fur-
ther information.
89