RAM 2015 1500, Руководство по эксплуатации, Страница: 388 / 998

Tighten the lug nuts/bolts in a star pattern until
each nut/bolt has been tightened twice.
After 25 miles (40 km) check the lug nut/bolt
torque to be sure that all the lug nuts/bolts are
properly seated against the wheel.
WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the lug nuts fully until the
vehicle has been lowered. Failure to follow
this warning may result in personal injury.
JACKING AND TIRE
CHANGING
Jacking And Tire Changing
1500 Series Trucks
WARNING!
•
Do not attempt to change a tire on the side
of the vehicle close to moving traffic. Pull
far enough off the road to avoid the danger
of being hit when operating the jack or
changing the wheel.
•
Being under a jacked-up vehicle is danger-
ous. The vehicle could slip off the jack and
fall on you. You could be crushed. Never
put any part of your body under a vehicle
that is on a jack. If you need to get under a
raised vehicle, take it to a service center
where it can be raised on a lift.
•
Never start or run the engine while the
vehicle is on a jack.
(Continued)
WARNING! (Continued)
•
The jack is designed to be used as a tool
for changing tires only. The jack should not
be used to lift the vehicle for service pur-
poses. The vehicle should be jacked on a
firm level surface only. Avoid ice or slippery
areas.
NOTE:
If your vehicle is equipped with an air sus-
pension system, there is a feature which
allows the automatic leveling to be disabled
to assist with changing a tire.
If your vehicle is equipped with a touchscreen,
this feature can be activated through the
Uconnect® system. Refer to “Uconnect® Set-
tings” in “Understanding Your Instrument Panel”
for further information.
4 And 5 Lug Nuts/Bolts Torque Pattern
385