Replacing Exterior Bulbs
BASE QUAD: LOW BEAM HEADLAMP, HIGH
BEAM HEADLAMP, FRONT PARK AND TURN —
IF EQUIPPED
Please see an authorized dealer for service on LED
lamps.
LED Reflector Headlamp
Front Park And Turn
See the following steps to replace:
1. Open the hood.
2. Disconnect and isolate the negative battery cable.
3. Locate the park and turn socket, which can be
found on the back side of the headlamps.
Park And Turn Socket
4. Reach behind the headlamp and unlock the
park and turn socket from the lamp by rotating
counterclockwise a quarter turn.
5. Pull the bulb straight out from the housing.
6. Separate the bulb from the socket without twisting.
7.
Reverse the procedure for installation of new bulb
and covers.
FOG LAMPS
Please see an authorized dealer for service on LED
front fog lamps.
REAR TAIL/STOP, TURN SIGNAL AND BACKUP
LAMPS
1. Remove the two screws and pushpin retainers that
pass through the bed sheet metal.
Tail Lamp Locations
1 — Tail Lamp
2 — Fasteners
3 — Pushpin Retainers
2. Pull the outboard side of the lamp rearward far
enough to unsnap the two receptacles on the
outboard side of the lamp housing from the two
plastic snap post retainers in the outer box side
panel.
Tail Lamp Removal
3. Disconnect the wiring harness connectors from the
bulb socket.
Wiring Harness Connector
4. Rotate the bulb socket counterclockwise a quarter
turn to unlock it from the housing.
5. Pull the bulb straight out of the socket.
330 SERVICING AND MAINTENANCE