NOTE:
Once RRCC is activated, other cruise functions are not
possible such as Active Driving Assist (ADA), Active Lane
Management (ALM), Advance Driving Assist (ADAS) and
Adaptive Cruise Control (ACC).
R
OUGH
R
OAD
C
RUISE
C
ONTROL
(RRCC)
O
PERATION
Rough Road Cruise Control is turned on/off by pushing
the Selec-Speed Control button located below your
rotary electronic gear selector. Once pushed, an LED
light will illuminate.
Selec-Speed Control Button
To Activate/Deactivate
Push and release the Selec-Speed Control button. The
Rough Road Cruise Control menu in the instrument
cluster displays “Rough Road Cruise Control Ready.”
To turn the system off, push and release the Selec-
Speed Control button again. At this time, the system
will turn off and the instrument cluster displays “Rough
Road Cruise Control Off.”
To Set A Desired Speed
When the vehicle reaches the speed of 5 mph (8 km/h),
push the SET (+) button or the SET (-) button and
release. The instrument cluster display will show the
set speed. With speed set, holding SET (+) button or the
SET (-) continues incrementing the speed by 1, not by 5
as with ACC.
NOTE:
Rough Road Cruise Control cannot be set below 5 mph
(8 km/h).
NOTE:
Rough Road Cruise Control cannot be set above 20
mph (32 km/h).
To Cancel
The following conditions cancel the Rough Road Cruise
Control system:
●
The brake pedal is applied
●
The CANC (cancel) button is pushed
●
The transfer case is shifted to 4WD Neutral or 4WD
Low
●
Speed exceeds 30 mph (48 km/h) for 70 seconds
or immediately if vehicle speed exceeds 45 mph (72
km/h) due to driver override
●
The gear selector is removed from the DRIVE
position
●
The vehicle parking brake is applied
●
The braking temperature exceeds normal range
(overheated)
To Resume
If the Selec-Speed Control button is still activated, push
the RES (resume) button and remove your foot from the
accelerator pedal. The instrument cluster display will
show the last set speed.
Resume can be used at any speed between 5 mph (8
km/h) and 20 mph (32 km/h).
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed
that is too high or too low for prevailing traffic and
road conditions could cause the vehicle to accelerate
or decelerate too sharply for safe operation. Failure
to follow these warnings can result in a collision and
death or serious personal injury.
PARKSENSE FRONT/REAR PARK ASSIST
SYSTEM — IF EQUIPPED
The ParkSense Park Assist system provides visual and
audible indications of the distance between the rear
and/or front fascia/bumper and a detected obstacle
when backing up or moving forward (e.g. during a
parking maneuver). If your vehicle is equipped with the
automatic braking function, the vehicle brakes may be
automatically applied and released when the vehicle is
in REVERSE if the system detects a possible collision
with an obstacle.
NOTE:
●
The driver can disable the automatic braking
function by turning ParkSense off via the ParkSense
STARTING AND OPERATING 153
4
