STARTING AND OPERATING
171
REFUELING THE VEHICLE
The capless fuel filler is located on the left side of the
vehicle.
The capless system is sealed by two flapper doors.
1. Put the vehicle in PARK and switch the ignition off.
2. Push the center-rear edge of the fuel filler door
(3 o'clock position) and release to open.
Fuel Filler Door
3. Insert the fuel nozzle fully into the filler pipe, the
nozzle opens and holds both flapper doors while
refueling.
Fuel Filler
4. When the fuel nozzle “clicks” or shuts off, the fuel
tank is full.
5. Keep the nozzle in the filler for five seconds after
nozzle clicks to allow fuel to drain from the nozzle.
6. Remove the fuel filler nozzle.
7. To close the fuel filler door, push the center-rear edge
(3 o’clock position) of the fuel filler door and then
release. The fuel filler door will latch closed.
NOTE:
In certain cold conditions, ice may prevent the fuel filler
door from opening. If this occurs, lightly push on the fuel
filler door around the perimeter to break the ice build up.
WARNING!
Never have any smoking materials lit in or near the
vehicle when the fuel door is open or the tank is
being filled.
Never add fuel when the engine is running. This is in
violation of most state and federal fire regulations
and may cause the MIL to turn on.
A fire may result if gasoline is pumped into a portable
container that is inside of a vehicle. You could be
burned. Always place gas containers on the ground
while filling.
CAUTION!
To avoid fuel spillage and overfilling, do not “top off” the
fuel tank after filling.
WARNING!
Always place container on the ground before filling.
Keep the pump nozzle in contact with the container
when you are filling it.
Use only approved containers for flammable liquid.
Do not leave container unattended while filling.
A static electric charge could cause a spark and
fire hazard.
4
23_DT_OM_EN_USC_t.book Page 171
Содержание 1500 2023
Страница 97: ...GETTING TO KNOW YOUR INSTRUMENT PANEL 95 HIGHLINE INSTRUMENT CLUSTER GASOLINE 3 23_DT_OM_EN_USC_t book Page 95 ...
Страница 358: ...356 SERVICING AND MAINTENANCE Underhood Power Distribution Center 23_DT_OM_EN_USC_t book Page 356 ...
Страница 378: ...376 SERVICING AND MAINTENANCE 23_DT_OM_EN_USC_t book Page 376 ...