RAM 1500 2022, Руководство пользователя

Страница: 95 / 496

GETTING TO KNOW YOUR VEHICLE 93
B
ED
R
AIL
T
IE
-D
OWN
S
YSTEM
—
I
F
E
QUIPPED
There are two adjustable cleats on each side of the
bed that can be used to assist in securing cargo.
Adjustable Cleats
Each cleat must be located and tightened down in
one of the detents, along either rail, in order to
keep cargo properly secure.
To move the cleat to any position on the rail, turn
the nut counterclockwise, approximately three
turns. Then pull out on the cleat and slide it to the
detent nearest the desired location. Make sure the
cleat is seated in the detent and tighten the nut.
Adjustable Cleat Assembly
Cleat Removal (Standard Box Rail)
To remove the cleats from the utility rail, slide the
cleat forward to access the cut out at the end of the
box rail, then remove the cleat.
Slide Cleat Forward To Remove
Cleat Removal (With Tonneau Cover)
To remove the cleats from the utility rail, remove
the end cap screw located in the center of the end
cap, using a #T30 Torx head driver. Remove the
end cap and slide the cleat off the end of the rail.
End Cap Screw Location With Tonneau Cover
CAUTION!
The maximum load per cleat should not exceed
250 lb (113 kg), or 500 lb (227 kg) total per rail,
and the angle of the load on each cleat should
not exceed 45 degrees above horizontal, or
damage to the cleat or cleat rail may occur.
1 — Utility Rail Detent
2 — Cleat Retainer Nut
3 — Utility Rail Cleat
2
22_DT_OM_EN_USC_t.book Page 93