RAM 1500 2021, Руководство пользователя

Страница: 293 / 461

SAFETY 291
Deactivating HDC
HDC will be deactivated but remain available if any
of the following conditions occur:

The driver overrides HDC set speed with throttle
or brake application.

The vehicle speed exceeds 20 mph (32 km/h)
but remains below 40 mph (64 km/h).

The vehicle is on a downhill grade of insufficient
magnitude, is on level ground, or is on an uphill
grade.

The vehicle is shifted to PARK.
Disabling HDC
HDC will be deactivated and disabled if any of the
following conditions occur:

The driver pushes the HDC switch.

The driveline is shifted out of the 4WD Low.

The parking brake is applied.

The driver door opens.

The vehicle is driven greater than 20 mph
(32 km/h) for greater than 70 seconds.

The vehicle is driven greater than 40 mph
(64 km/h) (HDC exits immediately).

HDC detects excessive brake temperature.
Feedback To The Driver
The instrument cluster has an HDC icon and the
HDC switch has an LED icon, which offers feedback
to the driver about the state HDC is in.

The cluster icon and switch lamp will illuminate
and remain on solid when HDC is enabled or
activated. This is the normal operating condition
for HDC.

The cluster icon and switch lamp will flash for
several seconds, then extinguish when the
driver pushes the HDC switch but enable condi -
tions are not met.

The cluster icon and switch lamp will flash for
several seconds, then extinguish when HDC
disables due to excess speed.

The cluster icon and switch lamp will flash when
HDC deactivates due to overheated brakes. The
flashing will stop and HDC will activate again
once the brakes have cooled sufficiently.
Hill Start Assist (HSA)
HSA is designed to mitigate roll back from a
complete stop while on an incline. If the driver
releases the brake while stopped on an incline,
HSA will continue to hold the brake pressure for a
short period. If the driver does not apply the
throttle before this time expires, the system will
release brake pressure and the vehicle will roll
down the hill as normal.
The following conditions must be met in order for
HSA to activate:

The feature must be enabled.

The vehicle must be stopped.

The parking brake must be off.

The driver door must be closed.

The vehicle must be on a sufficient grade.

The gear selection must match vehicle uphill
direction (i.e., vehicle facing uphill is in forward
gear; vehicle backing uphill is in REVERSE gear).

HSA will work in REVERSE gear and all forward
gears. The system will not activate if the trans -
mission is in PARK or NEUTRAL.
WARNING!
HDC is only intended to assist the driver in
controlling vehicle speed when descending hills.
The driver must remain attentive to the driving
conditions and is responsible for maintaining a
safe vehicle speed.
6