AUXILIARY SWITCHES — IF EQUIPPED
There can be up to five auxiliary switches located in the lower switch bank of the
instrument panel which can be used to power various electronic devices and PTO
(Power Take Off) – If Equipped. If Power Take Off is equipped, it will take the place
of the fifth Auxiliary switch. Connections to the switches are found under the hood in
the connectors attached to the auxiliary Power Distribution Center.
You have the ability to configure the functionality of the auxiliary switches via the
instrument cluster display. All switches can now be configured for setting the switch
type operation to latching or momentary, power source of either battery or ignition,
and ability to hold last state across key cycles.
NOTE:
Holding last state conditions are met when switch type is set to latching and power
source is set to ignition.
For further information on using the auxiliary switches, please refer to the Ram Body
Builders Guide by accessing www.rambodybuilder.com and choosing the appropriate
links.
E L E C T R O N I C S
203
Содержание 1500 2017
Страница 7: ...INTRODUCTION WELCOME 5 ...
Страница 369: ...NOTES 367 ...
Страница 370: ...NOTES 368 ...