RAM® TOUGH-TRAY™ ASSEMBLY INSTRUCTIONS
PARTS INDEX
A. RAM LAPTOP TRAY HOUSING (QTY. 1)
B. RAM LAPTOP TRAY SLIDE (QTY. 1)
C. RAM RETAINING SIDE ARMS (QTY. 4)
D. SPRING (QTY. 1)
E. #10-24 X 7/8” LONG PAN HEAD MACHINE SCREWS (QTY. 8)
F. #10-24 STAINLESS STEEL THIN NYLOCK NUTS (QTY. 8)
G. #8-32 X 5/8” LONG PAN HEAD MACHINE SCREWS (QTY. 2)
H. #10 STAINLESS STEEL FLAT WASHERS (QTY. 2)
J. #8-32 STAINLESS STEEL NYLOCK NUTS (QTY. 2)
TOOLS NEEDED
-PHILLIPS HEAD SCREWDRIVER
-3/8” OPEN END WRENCH (OR ADJUSTABLE WRENCH)
-PEN OR PENCIL
1.
PLACE YOUR LAPTOP ON (B) SLIDE. POSITION TWO (C)
SIDE ARMS AGAINST SLIDE SO THAT RUBBER KEEPERS
REST ON LAPTOP. COUNT THE VISIBLE RIDGES UNDER
BOTH SIDE KEEPERS TO ENSURE EVEN PLACEMENT.
SOME LAPTOPS REQUIRE FRONT AND REAR SIDE ARMS
TO BE SET AT DIFFERENT HEIGHTS.
COUNT RIDGES UNDER SIDE ARM
2.
REMOVE YOUR LAPTOP. ATTACH SAME SIDE ARMS TO (B) SLIDE USING (E)
SCREWS AND (F) NUTS. SIDE ARMS MUST BE POSITIONED ABOVE SAME
NUMBER OF RIDGES AS COUNTED IN STEP 1. TO AVOID BLOCKING PORTS
ON YOUR LAPTOP, POSITION ARMS APPROPRIATELY BEFORE TIGHTENING.
HOLD NUT IN PLACE WITH WRENCH, AND TIGHTEN WITH SCREWDRIVER.
(E) SCREWS ON OUTSIDE
REPEAT STEPS 1 AND 2 FOR (A) HOUSING PORTION OF TOUGH-TRAY.
3.
ATTACH (D) SPRING TO (B) SLIDE USING (G)
SCREW, (H) WASHER AND (J) NUT AS SHOWN.
4.
INSERT (B) SLIDE INTO (A) HOUSING. INSERT (G) SCREW AND
(H) WASHER THROUGH OPEN END OF (D) SPRING.
5.
EXPAND (D) SPRING UNTIL SCREW FROM
STEP 4 ALIGNS WITH HOLE IN TRAY HOUSING.
TIGHTEN SCREW THROUGH HOLE WITH (J)
NUT POSITIONED ON OPPOSITE SIDE.
6.
WHILE HOLDING TOUGH-TRAY SIDEWAYS, INSERT (F) NUT INTO HEX HOLE
OF TRAY. KEEP NUT POSITIONED CORRECTLY BY INSERTING WITH A PEN OR
PENCIL. HOLDING NUT IN PLACE, TURN TRAY UPSIDE DOWN AND POSITION
RAM-202
(INCLUDED IN VEHICLE MOUNT KIT) OVER 4 HOLES UNDER TRAY.
SECURE (E) SCREW THROUGH
RAM-202
ONTO (F) NUT UNDER TRAY, AND
REPEAT FOR REMAINING 3 HOLES. TIGHTEN ALL SCREWS.
USE AMPS 4-HOLE PATTERN
A
B
C
E
D
F
G
H
J
(B) SLIDE
(A) HOUSING
SLIDE
HOUSING
POSITION (J) NUT ON
OPPOSITE SIDE
TO ENSURE EVEN PLACEMENT
RMR-INS-2343
RAM Mounting Systems
8410 Dallas Ave S
Seattle, WA 98108
Phone: (206) 763-8361
Fax: (206) 763-9615
www.rammount.com
[email protected]
