RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 88 / 284

2. As soon as you cycle the ignition switch to the ON
position, you will see the Malfunction Indicator Light
(MIL) symbol come on as part of a normal bulb
check.
3. Approximately 15 seconds later, one of two things
will happen:
•
The MIL will flash for about 10 seconds and then
return to being fully illuminated until you turn OFF
the ignition or start the engine. This means that your
vehicle's OBD II system is
not ready
and you should
not
proceed to the I/M station.
•
The MIL will not flash at all and will remain fully illu-
minated until you place the ignition in the off posi-
tion or start the engine. This means that your vehi-
cle's OBD II system is
ready
and you can proceed to
the I/M station.
If your OBD II system is
not ready,
you should see an
authorized dealer or repair facility. If your vehicle was
recently serviced or had a battery failure or replace-
ment, you may need to do nothing more than drive your
vehicle as you normally would in order for your OBD II
system to update. A recheck with the previously men-
tioned test routine may then indicate that the system is
now ready
.
86 GETTING TO KNOW YOUR INSTRUMENT PANEL