RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 48 / 284

NOTE:
The Digital Rearview Mirror is not as effective when
driving in the following conditions:
•
Nighttime in low light applications
•
Bad weather conditions (e.g. extreme haze,
snow/slush)
If it becomes difficult to see clearly in the display, the
camera may need to be cleaned. If snow, ice, mud, or
any foreign substance builds up on the camera lens,
clean the lens, rinse with water, and dry with a soft
cloth. Do not cover the lens.
OUTSIDE MIRRORS
To receive maximum benefit, adjust the outside mir-
ror(s) to center on the adjacent lane of traffic with a
slight overlap of the view obtained on the inside mirror.
WARNING!
Vehicles and other objects seen in an outside convex
mirror will look smaller and farther away than they
really are. Relying too much on side convex mirrors
could cause you to collide with another vehicle or
other object. Use your inside mirror when judging the
size or distance of a vehicle seen in a side convex
mirror.
Outside Mirrors Folding Feature
All outside mirrors are hinged and may be folded for-
ward or rearward to avoid damage. The hinges have
three detent positions:
•
Full forward position
•
Full rearward position
•
Normal position
OUTSIDE MIRRORS WITH TURN
SIGNAL AND APPROACH
LIGHTING — IF EQUIPPED
Driver and passenger outside mirrors with turn signal
and approach lighting contain four LEDs, which are
located in the upper outer corner of each mirror.
Three of the LEDs are turn signal indicators, which flash
with the corresponding turn signal lights in the front
and rear of the vehicle. Turning on the Hazard Warning
flashers will also activate these LEDs.
The fourth LED supplies illuminated entry lighting,
which turns on in both mirrors when you use the key fob
or open any door. This LED shines outward to illuminate
the front door handles. It also shines downward to illu-
minate the area in front of the doors.
The illuminated entry lighting fades to off after about
30 seconds or it will fade to off immediately once the
ignition is placed into the ON/RUN position.
NOTE:
The approach lighting will not function when the gear
selector is moved out of the PARK position.
POWER MIRRORS — IF EQUIPPED
The power mirror controls are located on the driver’s
side door trim panel.
To adjust a mirror, turn the control knob toward the left
upper, left lower, right upper or right lower mirror posi-
tions indicated by one of the four arrows on the switch.
Tilt the control knob in the direction you want the mirror
to move. When you are finished adjusting the mirror,
turn the control to the center O (off) position to prevent
accidentally moving a mirror.
Camera Location
Power Mirror Controls
46 GETTING TO KNOW YOUR VEHICLE