RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 29 / 284

In case the ignition switch does not change with the
push of a button, the key fob may have a low or fully
depleted battery. A low key fob battery can be verified
by referring to the instrument cluster display, which will
display directions to follow
page 269.
To Lock/Unlock The Doors
To lock all of the doors, push and release the lock but-
ton once. Push and release the front unlock button on
key fob once to unlock only the front doors (figure 1) or
push and release the unlock button on key fob once to
unlock all doors (figure 2). Push and release the cargo
unlock button on key fob once to unlock the cargo area
(rear lateral sliding doors and rear door). The doors can
also be locked and unlocked manually by using the
mechanical key.
When the doors are unlocked, the turn signals will
flash. When the doors are locked, the turn signals will
flash and the horn will chirp (if equipped and activated
through the Uconnect Settings
page 136). If a door
is open when the lock button is pushed, the turn signal
lights will flash at an increased rate to indicate that a
door is still open.
Key Left Vehicle Feature
If a valid key fob is no longer detected inside the vehicle
while the vehicle’s ignition system is in the ON/RUN or
START position, the message “Key Fob Has Left The
Vehicle” will be shown in the instrument cluster display
along with an interior chime. An exterior audible and
visual alert will also be activated to warn the driver.
The vehicle’s horn will rapidly chirp three times along
with a single flash of the vehicle’s exterior lights.
NOTE:
•
The doors have to be open and then closed in order
for the vehicle to detect a key fob. The Key Left
Vehicle feature will activate when the first door is
closed and no key fob is detected in the vehicle. If
the warning has been activated, and the other doors
are closed, no other warning will be issued.
•
These alerts will not be activated in situations where
the vehicle’s engine is left running with the key fob
inside, or the key fob’s wireless signals are blocked.
Replacing The Battery In The Key Fob
The replacement battery is one CR2032 battery.
NOTE:
•
Customers are recommended to use a battery
obtained from Mopar®. Aftermarket coin battery
dimensions may not meet the original OEM coin
battery dimensions.
•
Perchlorate Material — special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate
for further information.
•
Do not touch the battery terminals that are on the
back housing or the printed circuit board.
1. Remove the emergency key (2) by sliding the emer-
gency key release (1) on the back of the key fob and
pulling the emergency key out with your other hand.
Figure 2 - Keyless Ignition Key Fob
1 — All Doors Unlock
2 — Emergency Key
3 — Lock
4 — Remote Start (If Equipped)
5 — Panic
Emergency Key Removal
1 — Emergency Key Release Button
2 — Emergency Key
GETTING TO KNOW YOUR VEHICLE 27
2