RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 205 / 284

Bottle release button, then push the bottle into the
housing by holding the button. An audible click will
be heard indicating the bottle is locked into place.
Release the button.
7. Verify that the cap is installed on the fitting at the
end of the Sealant Hose and return the hose to its
storage area (located on top of the housing).
8. Return the Tire Service Kit to its storage location in
the vehicle.
JUMP STARTING — GAS MODELS
If your vehicle has a discharged battery, it can be jump
started using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump starting can be dangerous if done improp-
erly, so please follow the procedures in this section
carefully.
NOTE:
When using a portable battery booster pack, follow the
manufacturer’s operating instructions and precautions.
WARNING!
Do not attempt jump starting if the battery is frozen. It
could rupture or explode and cause personal injury.
CAUTION!
Do not use a portable battery booster pack or any
other booster source with a system voltage greater
than 12 Volts or damage to the battery, starter motor,
alternator or electrical system may occur.
PREPARATIONS FOR JUMP START —
GAS MODELS
The vehicle’s jump starting remote posts are located
under the hood, in the engine compartment on the driv-
er's side.
The Remote positive
(+)
Post is covered with a protec-
tive cap located on the side of the Front Power Distribu-
tion Center.
The Remote negative
(-)
Post is located on the core sup-
port closest to the front of the vehicle.
See the following steps to prepare for jump starting:
1. Apply the parking brake, shift the automatic trans-
mission into PARK (P) and turn the ignition to the
OFF position.
2. Turn off the heater, radio, and all electrical
accessories.
3. Pull upward and remove the protective cover over
the remote positive
(+)
battery post.
4. If using another vehicle to jump start the battery,
park the vehicle within the reach of the jumper
cables, apply the parking brake and make sure the
ignition is OFF.
WARNING!
•
Do not allow vehicles to touch each other as this
could establish a ground connection and personal
injury could result.
•
Take care to avoid the radiator cooling fan when-
ever the hood is raised. It can start anytime the
ignition switch is ON. You can be injured by moving
fan blades.
•
Remove any metal jewelry such as rings, watch
bands and bracelets that could make an inadver-
tent electrical contact. You could be seriously
injured.
•
Batteries contain sulfuric acid that can burn your
skin or eyes and generate hydrogen gas which is
flammable and explosive. Keep open flames or
sparks away from the battery.
JUMP STARTING PROCEDURE —
GAS MODELS
WARNING!
Failure to follow this jump starting procedure could
result in personal injury or property damage due to
battery explosion.
Jump Starting Locations
Remote Positive (+) Post
Remote Negative (-) Post
IN CASE OF EMERGENCY 203
7