RAM Commercial ProMaster 2024, Руководство пользователя, Страница: 202 / 284

• Selecting Sealant Mode
Push in the Mode Select Knob and turn
to this position to inject the Tire Service
Kit Sealant and to inflate the tire. Use the
Sealant Hose when selecting this mode.
•
Using The Power Button
Push and release the Power Button once
to turn on the Tire Service Kit. Push and
release the Power Button again to turn
off the Tire Service Kit.
•
Using The Deflation Button
Push the Deflation Button to reduce the
air pressure in the tire if it becomes
overinflated.
TIRE SERVICE KIT USAGE
PRECAUTIONS
•
The Sealant Bottle and Sealant Hose are a one tire
application use and need to be replaced after each
use. Always replace these components immediately
at your original equipment vehicle dealer.
•
When the Tire Service Kit sealant is in a liquid form,
clean water and a damp cloth will remove the mate-
rial from the vehicle or tire and wheel components.
Once the sealant dries, it can easily be peeled off
and properly discarded.
•
For optimum performance, make sure the valve
stem on the wheel is free of debris before connect-
ing the Tire Service Kit.
•
You can use the Tire Service Kit air pump to inflate
bicycle tires. The kit also comes with two needles,
located in the Accessory Storage Compartment (on
the bottom of the air pump) for inflating sport balls,
rafts, or similar inflatable items. However, use only
the Air Pump Hose and make sure the Mode Select
Knob is in Air Mode when inflating such items to
avoid injecting sealant into them. The Tire Service
Kit Sealant is only intended to seal punctures less
than 1/4 inch (6 mm) diameter in the tread of your
tire.
•
Do not lift or carry the Tire Service Kit by the hoses.
WARNING!
•
Do not attempt to seal a tire on the side of the
vehicle closest to traffic. Pull far enough off the
road to avoid the danger of being hit when using
the Tire Service Kit.
•
Do not use Tire Service Kit or drive the vehicle
under the following circumstances:
○
If the puncture in the tire tread is approximately
1/4 inch (6 mm) or larger.
○
If the tire has any sidewall damage.
○
If the tire has any damage from driving with
extremely low tire pressure.
○
If the tire has any damage from driving on a flat
tire.
○
If the wheel has any damage.
○
If you are unsure of the condition of the tire or
the wheel.
•
Keep Tire Service Kit away from open flames or
heat sources.
•
A loose Tire Service Kit thrown forward in a colli-
sion or hard stop could endanger the occupants of
the vehicle. Always stow the Tire Service Kit in the
place provided. Failure to follow these warnings
can result in injuries that are serious or fatal to
you, your passengers, and others around you.
•
Take care not to allow the contents of Tire Service
Kit to come in contact with hair, eyes, or clothing.
Tire Service Kit sealant is harmful if inhaled, swal-
(Continued)
WARNING!
lowed, or absorbed through the skin. It causes
skin, eye, and respiratory irritation. Flush immedi-
ately with plenty of water if there is any contact
with eyes or skin. Change clothing as soon as pos-
sible, if there is any contact with clothing.
•
Tire Service Kit Sealant solution contains latex. In
case of an allergic reaction or rash, consult a phy-
sician immediately. Keep Tire Service Kit out of
reach of children. If swallowed, rinse mouth imme-
diately with plenty of water and drink plenty of
water. Do not induce vomiting! Consult a physician
immediately.
SEALING A TIRE WITH TIRE
SERVICE KIT
(A) Whenever You Stop To Use Tire
Service Kit:
1. Pull over to a safe location and turn on the vehicle’s
Hazard Warning Flashers.
2. Verify that the valve stem (on the wheel with the
deflated tire) is in a position that is near to the
ground. This will allow the Tire Service Kit Hoses
and to reach the valve stem and keep the Tire Ser-
vice Kit flat on the ground. This will provide the best
positioning of the kit when injecting the sealant into
the deflated tire and running the air pump. Move the
vehicle as necessary to place the valve stem in this
position before proceeding.
3. Place the transmission in PARK (P) (auto transmis-
sion) or in Gear (manual transmission) and place
the ignition in the OFF position.
4. Apply the parking brake.
200 IN CASE OF EMERGENCY