Ralco R 221 ACS DHHS Series, Инструкция по эксплуатации

Страница: 61 / 245

MTR 221 ACS - MTR 221 ACS DHHS
MANUALE ISTRUZIONI / INSTRUCTION MANUAL
S
YSTEM
S
TART
-U
P
53
Model R 221 ACS - R 221 ACS DHHS
MTR 221
ACS
-
MTR 221
ACS
DHHS
- Sy
stem Star
t-Up
SYSTEM START-UP
On system power-up, the GC007 board software performs a series of tests aimed at self-
assessment. Depending on the position of the key at the back of the collimator, the automatic
or manual control phase will initiate on receipt of CanBus controls.
The display will then read the following information:
• Bootloader version of the
GC 009 board
• Firmware version of the GC 009 (Slave) board
• collimator model and its serial number (see programming of serial number)
Where 12345 stands for the serial number (see programming of serial number)
• collimator model, customer name and SW of the GC 007 (Master) board
• current collimator parameters:
• current filtering level will be shown if a four-position radiological filter (0 Al) is in place:
If the operator wishes to configure the system to different requirements, the configuration must
be initiated by keeping the FILTER and the LIGHT push buttons pressed for approximately 5
seconds..
Current CanBus communication speed is displayed; this value may be changed with the use
of the dipswitches placed on the
GC 007 board. See Chapter E
LECTRONIC
S
YSTEM
.
GC- 009 BOOTLOADER
v. 1.02
GC- 009 ver. 1.02
R 2 2 1 A C S C o l l i m a t o r
S e r i a l N u m b e r 1 2 3 4 5
R221 ACS - STANDARD
Sw. 1.10
C R O S S 0 L O N G 0
S I D 0
C R O S S 0 L O N G 0
S I D 0 0 A L