Ralco R 221 ACS DHHS Series, Инструкция по эксплуатации

Страница: 113 / 245

MTR 221 ACS - MTR 221 ACS DHHS
MANUALE ISTRUZIONI / INSTRUCTION MANUAL
A
DJUSTMENTS
105
Model R 221 ACS - R 221 ACS DHHS
MTR 221
ACS
-
MTR 2
21
AC
S DHH
S - Adjustments
ADJUSTMENTS
C
ROSSHAIR
A
DJUSTMENT
• Activate the light field.
• Adjust the light field to a narrow line for each pair of shutters
by turning the two knobs alternately.
• Check that the project cross line is exact halfway between
the edges of the shutters, see Fig. Cross Line .
• If adjustment is required, remove the cover from the sides
and bottom of the collimator, see Chapter - C
OVER
R
EMOVAL
.
• Loosen the four screws securing the plastic panel and adjust
the cross lines to coincide with the light lines, see Chapter -
C
OVER
R
EMOVAL
.
• Tighten the screws.
L
ASER
A
DJUSTMENT
• Remove part of the cover to access
the point of adjustment, see Chapter-
C
OVER
R
EMOVAL
.
• The line is to fall on a perpendicular
cross-line on the plastic anti-dust
panel near the collimator controls,
see
Fig. Laser Line.
• Adjust the position of the line by rotat-
ing the laser or moving the base of
the laser system.
• To rotate the laser system,
loosen the Allen screw A , see
Fig. Laser Adjustment.
• Tighten the Allen screw when
the laser beam falls on or is
parallel to the bisector line
drawn on the anti-dust panel.
• Tilt the laser system by loosening the
two B screws holding the laser system base to the beam limiting device front plate.
W
ARNINGS
T
HIS IS PROVIDED AS AN AID TO THE END USER
. R
ALCO IS NOT LIABLE FOR
ANY DAMAGES RESULTING FROM THE ALTERING OF PRESET FACTORY
CONFIGURATIONS
.
A
DJUSTMENTS HAVE BEEN PRESET AT THE FACTORY PRIOR TO SHIPMENT OF
THE COLLIMATOR
.
SHOULD ANY PROBLEM ARISE REQUIRING THE NEED TO
RECALIBRATE
,
PLEASE CONTACT RALCO FOR ASSISTANCE BEFORE PROCEEDING
WITH THE ADJUSTMENT
.
Fig. Cross Line
Fig. Laser Adjustment