14
9.2 Triggering Macros from Maps
When a Macro is used it must be triggered from a map (this could also be from a WCM
map, WAVFR map etc.). Below Mapping 2 is an example of a map being used to trigger a
macro: in this case “Start Macro 2”.
10 Macros
Macros allow a sequence of actions to take place when triggered by an Event or Map. The
HUB can store up to 60 Macros each of which can have a maximum of 32 Steps.
The HUB Macro screen is located from the tab in the HUB device editor.
There are 3 steps in this example Macro:
-
Room 9, All Channels, Scene 2
-
Room 17, All Channels Scene 1
-
Room 49, All Channels Scene 2
With this simple Macro the HUB will just run through the three commands listed. More
complex functionality can be achieved by using commands in the tables outlined below.
WK-HUB
Manual Version 1.3.4
