Raisecom
Gazelle S1503i (A) User Manual
5
Hardware installation
Raisecom Technology Co., Ltd.
34
Item
Description
AC
Rated voltage: 110/220 VAC
Voltage range: 85–264 VAC
Backup
power
We recommend you to prepare the backup power to make sure that the
Gazelle S1503i can work properly when the power is abnormal.
Power
The power should be more than 5 W.
5.1.3 Electrostatic conditions
To prevent human electrostatic from damaging the Gazelle S1503i, you must wear the
Electrostatic Discharge (ESD) wrist strap before contacting the Gazelle S1503i. The ESD
wrist strap should contact your skin properly and make sure that the other side of the ESD
wrist strap is connected to the ground reliably.
5.1.4 Grounding conditions
The Gazelle S1503i must be grounded and the grounding resistance should be no more than 1
Ω. Grounding properly is a necessity for lightning protection and anti-interference.
5.1.5 Other conditions
Before installation, you should make sure that the corollary device is ready. For example,
cables and supporting facilities are correctly installed.
5.1.6 Precautions before opening packet
The Gazelle S1503i is packed in a special box; you should note the following items:
Place the packing box in the upright position.
Check the device and accessories according to the packing list.
5.2 Installing device
5.2.1 Installing device on guide rail
When the Gazelle S1503i is brought out of the packing box, it is installed with the
clamping rail connector on the rear panel. Take the DC model for example to
illustrate the installation process.
Follow following steps to install the Gazelle S1503i on the guide rail:
Step 1
Attach the clamping rail connector to the guide rail, as shown in Figure 5-1.