RainWise MKIII-LR Скачать руководство пользователя страница 5

Страница: 5 / 6

Switch 5 has no function.

Once power is applied, the repeater begins operating. Data reception is indicated by a blinking
red LED adjacent to the Radio Data label.

2.3)

Configuration

Matching the MKIII Sensor Assembly and Repeater codes.

The factory default code in the MKIII Sensor Assembly is code 0. Additionally, all of the
switches on the Repeater have the same factory default setting of 0. Therefore, unless you have
changed the default setting in the MKIII Sensor Assembly, it will communicate with the
Repeater as code 0.

If your MKIII Sensor Assembly has been set to a code other than 0, you must set the Repeater
code to match it.

To view the code setting in your MKIII Sensor Assembly, loosen the screws in each of the four
corners of the solar panel cover. Gently pull the solar panel cover away from the Sensor
Assembly until you can disconnect it from the motherboard. You will view the configuration
switches in the upper left corner of the motherboard. Switches #1 & #2 control the coding of the
Sensor Assembly and must be configured the same as switches #1 & #2 on the Repeater.

Setting the Repeater code for the receiving device(s).

The

Transmit

code configures communication between the Repeater and the receiving

device(s). This code can be set to any code that is different from the

Receive

code. Once a

Transmit

code has been selected, the receiving device(s) must be configured to match.

Please refer to the Owner's Manual of the appropriate receiving device for instructions to change
the code.

Product Support

If you are experiencing problems, or if you simply have questions about your product, please
contact our service department.