ESP-TM2 Controller
7
EN
Basic Programming
1. Set Date and Time
Turn the dial to DATE/TIME.
A
Press or to select the setting to change.
B
Press or to change the setting value.
C
Press and hold
-
or
+
to accelerate adjustments.
To change the time format (12 hour or 24 hour):
D
With
MINUTES
blinking, press .
E
Press or to select the desired time format,
then press to return to the time setting.
2. Set Watering Start Times
Up to four Start Times are available for each program.
Turn the dial to START TIMES.
A
Press Program Select to choose the desired
Program (if necessary).
B
Press or to select an available Start Time.
C
Press
or to set the selected Start Time
(ensure the AM/PM setting is correct).
D
Press to set additional Start Times.
3. Set Station Run Times
Run Times can be set from one minute up to six hours.
Turn the dial to RUN TIMES.
A
Press Program Select to choose the desired
Program (if necessary).
B
Press or to select a Station.
C
Press or to set the Run Time for the selected
Station.
D
Press to set additional Station Run Times.
NOTE: Rain Bird recommends that the maximum
irrigation zone cycle time be less than the time
required for runoff to begin and that there be
adequate soak time before the next irrigation
cycle of that same zone begins again.
4. Set Watering Days
Custom Days of the Week
Set watering to occur on specific days of the week.
Turn the dial to RUN DAYS.
A
Press Program Select to choose the desired
Program (if necessary).
B
Press or to set the selected (blinking) day as
either ON or OFF, and to automatically move to
the next day.
C
You can press or at any time to move the
cursor to the previous or next day.
NOTE: If Sunday is selected, will enter and
activate Cyclic Watering (see the Advanced Pro-
gramming section). If this is not desired, press the
button to return to watering by Custom Days.