Radwin Transportation FiberinMotion, Руководство по развертыванию

Страница: 21 / 122

FinM Deployment Guide Release 4.5.10 2 ‐ 8
TBS Mounting Site Installation
Vertical pole ‐ medium
1. Diameter 2 to 3: Before raising the TBS on the pole, position the pole clamp as shown in
the following two figures. Do not completely tighten the bolts:
2. Place this assembly on the pole where you want to mount the TBS. Once it is in place,
rotate the pole clamp as shown, then tighten both bolts.
Vertical Pole ‐ thick
1. Diameter larger than 3: Use worm drive clamps (not supplied), threaded through the holes
as shown in Figure 2 ‐ 13 , or U ‐ bolts (not supplied), fastened using the holes as shown in
Figure 2 ‐ 14 :
Figure 2 ‐ 9: Medium pole: Fasten clamp to
base plate
Figure 2 ‐ 10: Medium pole: Do not com ‐
pletely tighten bolts
Figure 2 ‐ 11: Medium pole: Rotate clamp Figure 2 ‐ 12: Medium pole: tighten bolts