Radwin 5000 HPMP, Руководство пользователя

Страница: 265 / 518

RADWIN 5000 HPMP User Manual Release 3.5.70 11 ‐ 21
Continuing Pre ‐ Configuration
change it to make the unit a DHCP client through a switch. The Received and Transmitted
figures are cumulative.
The VMU operates as one or more virtual AP (VAP) units up to a maximum of eight. For pre ‐
configuration purposes, the first available VAP, shown as WLAN 1, is set up by default with
name and SSID Install .
Notice further from the WLAN 1 table that each VAP has its own MAC address. From a service
perspective, the VAPs look like separate physical AP units.
We will configure three VAPs and check each one for connectivity with a remote laptop.
Continuing Pre-Configuration
Preparing the Radio Parameters
The System page items may be configured later. Open the Network page:
The Connection Type is Static IP address or DHCP. DHCP is the default.
The default IP address and subnet mask are provided for use with a static IP address or if the
DHCP server becomes unavailable. For demonstration purposes, we will leave them as is.
Now, open the Wireless page. The most important part of pre ‐ configuration is carried out
here.
Caution
Do not change the WLAN 1 SSID from Install to anything else until you are
certain that you are done with pre ‐ configuration. Changing the Install SSID
moves the unit into “service mode” disabling the DHCP/DNS server,
enabling Ethernet service and becoming addressable only over wire through
an IP address.