Radware APSolute Vision, Руководство по установке и обслуживанию, Страница: 64 / 81

APSolute Vision Installation and Maintenance Guide
Platform Installation
64 Document ID: RDWR_APSV_V400_IG1808
5. Click Finish .
6. In SCSII LVM1 select the disk as Virtio .
7. Click Apply .
8. Restart the machine. This will take a few minutes.
Once the machine restarts, it will contain the new volume and you can proceed with installing the
LVM.
To install LVM on the Virtual Machine
> Enter the command:
/opt/radware/box/bin/system_storage_lvm.sh
This opens the LVM feature allowing you to increase the disk size for storage.
Installing LVM for Microsoft Hyper-V
To increase the size of the storage logical volume
1. In the Hyper-V Manager, open the virtual machine and select File > Settings .
2. In the SCSII Controller , select Add > Hardware .
3. Select New and click Next
4. Change the name of the new disk (not to select the same name as the present disk which is
presented).
5. Set the capacity of the new hard disk.
6. Click
Finish .
7. Restart the machine. This will take a few minutes.
Once the machine restarts, it will contain the new volume and you can proceed with installing the
LVM.
To install LVM on the Virtual Machine
> Enter the command:
/opt/radware/box/bin/system_storage_lvm.sh
This opens the LVM feature allowing you to increase the disk size for storage.
Connecting to the APSolute Vision Platform
You can connect to the APSolute Vision platform via a Web interface or via the command line
interface (CLI).
• Connect over HTTPS to the Web interface using the management IP address.
• Connect to the CLI either by serial terminal, Telnet, or SSH. (You can use a terminal emulation
application.) Use an SSH client to open an SSH session to the management IP address of the
platform.