Radne Raket 120, Руководство пользователя

Страница: 7 / 28

6
7
7
User Manual
How to install the Raket 120 engine in a
chassis or frame
For the assembly of the Raket 120 engine four threaded holes, M8, are
provided in the bottom of the crankcase. For mounting the engine in a kart,
a special mounting plate is available (part No 3004) with mounting clamps
(part No 3005), which facilitates the assembly as well as the adjustment of
the chain tension.
Note, the correct length of the M8 bolt is important. The depth of the th-
readed hole is 20 mm. You should make sure that, when fully inserted in the
hole, the bolt uses at least 18 mm of the treaded hole, but also that the bolt
is not too long to penetrate into the crankcase.
For mounting the engine in a ULA, the specifics for each ULA will determine
the best mounting procedure.
The crankcase and the cover over the rope starter are made of aluminium.
You must protect all rotating parts for two reasons. First is to prevent you or
another person to come in contact with a chain or shaft where you can get
caught and be injured. Secondly, because of the high speed of the engine
(up to 15.000 rpm) very big forces are present. If a chain or shaft should
break, you must be protected against parts that can be thrown away. If you
feel uncertain about the design of these protections, you should consult
someone for professional help.
After you have mounted the engine to the frame or structure, you must
make the following connections:
·connect the fuel tank with the carburettor inlet nipple
·connect the accelerator pedal or equivalent with the throttle of the carburet-
tor
·connect the emergency breaker
These are all the connections needed.