O p e r a t i n g i n s t r u c t i o n s - B e l a l a t u s
ten
_ v 0 1 . d o c x
S e i t e
8
v o n
9
Operating instructions Radius belalatus® ten fan-
shaped awning
for end users
5
Operation with SOMFY Telis RTS
A connected sun and wind sensor can automatically move the fan to the stored midday and
parking position. These positions can also be approached via the Somfy handheld
transmitter by pressing the up and down button. This signal is present at the control unit
until it is replaced by the Somfy signal in the opposite direction, then it is present again.
If the fan is now moved to the middy or park position with the app or the remote control after
the Somfy control was active, the Somfy signal remains present for the control memory.
This means that if, for example, the fan automatically fans out in the sun and is then moved
to the park position by the app, it cannot be opened with the control, because for the
control's memory the fan is already open. To avoid this, you must first press the arrow key
on the somfy remote control in the opposite direction and only then can you open it with the
remote control.
If the fan is opened with the Smartphone App or the Vibradorm handheld transmitter, this
information is not known to the sun and wind monitoring system. If the solar radiation is not
sufficient in such a situation, then the stored position of the fan is "closed" for the sun and
wind monitor system!
This means that the system would not close automatically when
the wind comes up, because the position for the system is already "closed.
It must therefore be ensured that when the fan is connected to a sun and wind sensor
system, the Somfy Telis RT arrow key is always pressed downwards when the fan is
opened with the Smartphone App or the Vibradorm remote control.
If the system has been opened with the Somfy remote control or automatically with the wind
and sun sensor, it is no longer possible to move with the Radius App or Vibradorm remote
control for the next 4 minutes. This can be avoided by briefly pressing the stop button (my).
In case of changeable weather and/or gusty wind, the automatic sun protection system
must be switched off and the fan must be retracted. This prevents the fan from being
continuously retracted and extended without great benefit.This is also provided for in our
risk analysis.
Recommendation:
Recommendation: If a sun/wind monitor or a KNX bus system is used, it is recommended
that the midday and parking position is approached by these systems.
Fan moves to midday position (button up)
Motion is stopped
Fan moves into parking position (button down)
By keeping this key pressed, the sun monitor can be switched on and off.
This is then visible by the red LEDs "off" and "on".
