RadioLink RC6GS V2, Инструкция по эксплуатации

Страница: 8 / 30

RadioLink Electronic Ltd
www.radiolink.com
4
R7FG Working Mode
Working Mode Mode 1 Mode 2 Mode 3 Mode 4 Note
Indicator Color Green Blue
Red&Blue
(Purple)
Red&Green
(Orange)
/
With Gyro N N Y Y
Multicolor light indicator on
means gyro function on
Channel Corresponding signal output in different channel /
BAT+- Return port of model battery voltage /
1 PWM PWM PWM PWM Rudder
2 PWM PWM PWM PWM Throttle
3 PWM PWM PWM PWM Aux
4 PWM PWM PWM PWM Aux
5 PWM PWM PWM PWM Aux
6 PWM PWM PWM PWM Aux
PPM/S.B PPM SBUS SBUS PPM
Green is PPM, Blue is
S-BUS
，
flight controller can be
connected under SBUS/PPM
mode and achieve different
models control incl.
Mecanum
car/Robot/Engineering
Off-road cars
Signal Switch
Short press
ID set once
to Mode 2
Short press
ID set once
to Mode 1
Short press ID
set once to
Mode 4
Short press ID
set once to
Mode 3
/
Short press
ID set 3
times
quickly to
Mode 4
Short press
ID set 3
times
quickly to
Mode 3
Short press ID
set 3 times
quickly to
Mode 2
Short press ID
set 3 times
quickly to Mode
1
/
1.2.3 Gyro Setup
A. Gyro Enabled
Factory setting is gyro function OFF by default.
Short press ID SET three times with interval less than 1 second, the RED indicator flashes three times. Red
LED on/off indicates the gyro function is on/off.
B. Gyro Phase
When the gyro forward is enabled, try to turn the model car to check if the gyro is correcting the wheels.
Normally, the wheels should turn right to correct when the car is turned left while the wheels should turn left to
correct when the car is turned right. If the gyro phase is reversed, short press the binding button (ID SET)
twice in 1 second. The Red indicator flashes twice means the gyro phase setting is complete.